Brush Strokes Car Decal - 2 Color: A car decal in short brush stroke patterns which covers the car from bumper
Custom Brush Stroke After Market Vinyl Cut Decal Graphic for your Car or Truck. This decal kit includes 2 pieces of vinyl for each side of your vehicle.
PRICE INCLUDES BOTH SIDES
**Installation Not Included**
If you have questions please contact us at 858-408-0744 or email Info@ModernImage.net .
To assure your on-line order will be a complete success, below are simple to follow steps for installation of your vinyl graphic. Follow these steps closely, and your vinyl graphic will look good for years to come.
Surface Preparation
All surfaces must be thoroughly cleaned before applying your vinyl graphics. Follow the instructions below for specific material cleaning procedures.
* Small cutting knife or razor blade. (an Exacto Knife is ideal for the job)
* A Spray bottle filled with a mixture of dish soap and water.
* The mixture ratio is; 3 drops of soap to 1 pint of water Plastic Squeegee (supplied)
* Dry Towel
* 2" Roll of Masking Tape
Temperature Requirements
The temperature of the room and the temperature of the intended surface should be between 45 and 90 degrees Fahrenheit for best results. Very high humidity (above 90 percent) may effect the application process.
The graphic consists of three separate pieces.
* Pre-mask
* Vinyl Graphic
* Liner
To assure your on-line order will be a complete success, below are simple to follow steps for installation of your vinyl graphic. Follow these steps closely, and your vinyl graphic will look good for years to come.
Surface Preparation
All surfaces must be thoroughly cleaned before applying your vinyl graphics. Follow the instructions below for specific material cleaning procedures.
* Small cutting knife or razor blade. (an Exacto Knife is ideal for the job)
* A Spray bottle filled with a mixture of dish soap and water.
* The mixture ratio is; 3 drops of soap to 1 pint of water Plastic Squeegee (supplied)
* Dry Towel
* 2" Roll of Masking Tape
Temperature Requirements
The temperature of the room and the temperature of the intended surface should be between 45 and 90 degrees Fahrenheit for best results. Very high humidity (above 90 percent) may effect the application process.
The graphic consists of three separate pieces.
* Pre-mask
* Vinyl Graphic
* Liner
